Bronze Scales buy on Brown Leather Guitar Strap

This all leather guitar strap is made with a deep scale pattern embossed cowhide that has a bronze finish, which goes nearly black between scales, and this is layered over my chocolate brown cowhide strap.

This is likely patterned after alligator pattern, but there is no "head", as what I refer to as "horn back" 'gator on other listings. This has depth to the coloring, as well as almost a bubble feel to the embossing, though these scales do not pop like bubble wrap!

This is applied over a supple brown cowhide (color may vary from the as pictured pending my current stock, but will be as close in tone as possible), glued & edge stitched, leaving the adjustment slot area to show off the main strap cowhide.

The overall length of this strap as shown is adjustable from about 48" to 58", unless you request otherwise.

The main strap is hand cut to 2 1/2" wide, and tapers to about a 1 1/2" radius for the front peg end, and down to 2 1/8" width on the slot end.

The 1" wide adjustment strap is made with the same leather as the main strap so it can weave through the adjustment slots easily, but it is still firm, and will not stretch. The edges are trimmed with a small radius bevel tool to soften the look. The hide is through-dyed, so it is consistent dark brown on the edges as on its soft suede split underside.

The main strap is about 42" long, and the 11 slots are spaced from about 29" to 40" from the front peg hole. The adjustment strap is 18" from buy slot to its rear peg hole when installed. (I refer to the front peg hole being on the main strap, and the rear is the adjustment slot).

The 1" wide adjustment strap loops through the chosen slot and is woven through the other slots to provide the desired length and fixes to the back pin on the guitar. And I've laser etched my logo onto this smaller piece.

The holes for the pegs are punched at 5/16" in the front, and 3/8" in the back, and a small slit ends with a small hole at the top of the slit to prevent tears & the "keyhole" effect makes the strap easier to install & remove, and can accommodate most pegs. The firm leather and stitching around the front peg hole keeps strap to remain secured once it's fitted fully in place.

This design means the strap is only leather, and there is no metal or plastic hardware that could annoy you while you're playing, or your knock into you instrument while it's being moved or stored.

I can also provide leather "laces" if you prefer to tie the strap to the neck of the guitar, rather than using a front peg. And if you have a specific peg size you need to fit, please let me know. There is no extra charge for enlarging the peg holes or for the ties when you order the strap, but please note in the order if you want any of those changes.

If you have any questions, please convo me!