Siege Flesh buy Glutton | Man Eaters II | Bestiarum Miniatures | Dungeons and Dragons | Pathfinder | Painting

Size Options:
We get asked a lot about our unusual size options. Essentially we increase the size of a lot of our models in line with the size of the base increasing. So a figure with a 25mm base would be half the size of that same figure on a 50mm base. However, we are very happy to print the figures to be either slightly larger or smaller to fit with the height you need for your preferred system. All you need to do is let us know what height you want and pick a base size that is appropriate and we'll do our best to meet your requirements. If in doubt about anything at all just send us a message, we're happy to be precise so that you can purchase with confidence.

***32mm scale, 90mm base*** RealmShapers provides freshly 3D printed resin models in a neutral grey colour. If you are new to resin models you need to understand that you will need to do some finishing work to get the best results - some miniatures require supports which can leave small marks on the surface which can be removed with sanding. Larger models may also be hollowed out to improve print stability and as such will have resin drainage holes that are easily fixed with pva glue or plastic putty. I try to remove as many support struts as possible but sometimes the occasional one might not be removed - they are very easy to remove with a sharp craft knife. If there are bumps on the surface they can be easily and quickly sanded down but be very careful not to breathe in resin dust. If the model is glossy and hard it can be made matt with a stiff nylon brush (or carefully applied steel wire buy wool) or the glossiness can be removed by priming. In the unlikely event that a model is still sticky the best approach is to expose the model to direct sunlight and wash your hands with plenty of soap (resin is a skin irritant if left for long enough on skin). If you need any other advice on how to work with the model or have a problem I'm always happy to help out via Etsy messages.

This horrifyingly twisted visage of flesh and bone is the practiced cruelty of BESTIARUM MINIATURES (https://www.patreon.com/BestiarumMiniatures) - RealmShapers is a fully licensed printer of any of their miniatures.

This listing is for a high quality grey resin figure/furniture/landscape piece which comes unprimed - once primed it will be ideal for painting with an extremely high level of details preserved.