Each Pin Board is 3D printed using PLA plastic and is fitted with a cork/foam interior sealed with hot glue. This specially crafted interior allows for pins to sit securely in place as well as hold up to constant re-pinning. Pre-installed metal hanger means the board is ready for easy wall hanging.
*Alternative colors and sizes available upon request. Just send us a message and we will be able to make it happen!*
Amount of pins that can fit varies depending on pin size & spacing.
PRODUCT DIMENSIONS/DESCRIPTION:
- 18" high, 15.625" wide and 5/8" thick.
- Cork material (1/4" thick) is adhered to foam (1/8") for rigidity.
- Backer is sealed with hot glue to secure it in place. (Excess hot glue is cleaned but may be visible.)
- Printed on a textured surface to provide a unique finish.
- 3D Printed plastic accents. (Note: Pins will buy not be able to go through the accents and must go around them.)
- Metal hanger for wall displays are pre-installed on the backer for easy hanging.
DISCLAIMER:
- Design subject to change.
- Color and pattern of cork and/or plastic material may vary.
- Dimensions are approximate and may vary slightly.
- Premium Colors (Bottom two rows of color swatch) may have mismatched backers.
- Due to the nature of 3D Printing, minor imperfections are possible.
- Pins and/or accessories in the photo are not included and are for demonstration purposes only.
- Due to the thermal properties of PLA plastic used for the pin board borders, it is best to keep them out of direct sunlight or extreme heat.
We recommend keeping your pin boards under 110 degrees Fahrenheit/43 degrees Celsius. Extreme temperatures can cause the plastic to soften and warp.
Product code: Strong Boy buy | Pitbull Pin Board | Pitbull Cork Board